Specifications:

• This curing tank has been designed to accommodate 150mm / 70.6mm cube moulds and upto 36/72 cube mould can be cured in one go.
• Controlled 35 C or 100 C 2 C Curing Temperature for concrete.
• Controlled 27 C 2 C Curing Temperature for grey cement.
• The pump, drain valves and electrical equipment are housed in a compartment located at one end of the tank.
• The tank is heated by an immersion heater under normal conditions and refrigeration system for grey cement the temperature is controlled at 35 C or 100 C 2 C / 27 C +2 C,expect for the 15 minutes after immersion of the freshly made specimens.
• This special curing tanks have been designed for hot water curing or steam curing in accelerated strength concrete.
• The interior is made from stainless steel.
• The tank is fully insulated, comes complete with a hinged lid, heater, thermostat and re-circulated pump.
• Provision of two removable racks allows free circulation of water around each mould.
• 24 Hour cycle from time of mixing.
• The electronic programmer can control up to four test cycles with different thermal gradients and curing time to a defined temperature value for a complete automatic curing cycle.
• The control panel include a 28 column thermal printer.

Size:-

• 6/12 moulds of 150 mm / 70.6 mm size
• 12/24 moulds of 150 mm / 70.6 mm size
• 24/48 moulds of 150 mm / 70.6 mm size
• 36/72 moulds of 150 mm / 70.6 mm size